e-Sense Move Highbay is a lighting control system for industrial applications. The system is equipped with a dual Microwave and PIR sensor in the same unit which enables you to switch between presence detection techniques or utilise both simultaneously. Once presence is detected, a predetermined number of luminaires light up at a defined level helping to create a seamless yet energy efficient navigation throughout the space. e-Sense Move Highbay is available with either an aisle or open area lens for application specific detection areas.

How e-Sense Move Highbay works

e-Sense Move Highbay is a lighting control system where the sensors communicate via radio frequency. The sensors are integrated into a master luminaire which can then be connected to up to 20 slave luminaires via DALI. When presence is detected, information is sent to up to 15 master luminaires which then turn on, either at a full output or at defined levels specified during the commissioning process.

The dual sensor permits the user to switch between microwave or PIR presence detection or use both. A Microwave sensor can detect movement through thin physical constructions, such as doors, and the sensitivity can be easily adjusted. However, in applications where luminaires are situated near non-static technology, such as air ventilation systems which can activate detection via their vibration, the PIR functionality is specifically relevant. The ability to alternate within the same fitting offers unparalleled flexibility should layout or use of the space change over time.

To further optimize the system, e-Sense Move Highbay can be supplied with two different lens. The Aisle optic focuses the detection range in a narrow, rectangular fashion, while the Open Area lens has a medium/wide distribution for wider spaces.


Presence control

Lux threshold

Absence detection to switch off

Wireless communication

Remote control






The number of ‘linked’ luminaires, the low and high light level, the delay times between full, low and off and the desired detection sensor are all configured via a remote control. After configuring the first luminaire, you can save the settings and then apply them on a sensor by sensor basis which significantly reduces commission time in areas where a large number of luminaires should all act in the same fashion. 


Dual PIR/ Microwave sensor and RF unit (integrated in luminaires). The luminaire that registers presence sends an RF signal to the luminaire or luminaires that have been programmed to listen to the detecting luminaire.

Download brochure