fagerhult_dmx_colour_chaser_touch_eng.jpg

DMX control – Lexel colour control

DMX (RDM) installation using Philips Colour Chaser Touch

DMX control using the Philips Colour Chaser Touch provides many possibilities for personalised programming of light functions.

The panel can be mounted over a standard pattress or directly onto a wall. Power supply units could be placed e.g. above a suspended ceiling.

Installation is simple. Use ordinary network cables between the control panel and the loads. Connect each light source or drive unit to a 230 V power supply. Luminaires using DIP-switch addressing can be combined with luminaires using RDM addressing (via software).

Colour Chaser Touch 86240:

  • Touch button for TO/FROM.
  • Four saveable presets/light scenes.
  • Manual adjustment of colour (C), intensity (I) and saturation (S).
  • Software for advanced lighting setup – RDM addressing of light sources
  • Simple composition of light sequences using large number of preset colour themes.
  • Colour setup can be sampled from images.
  • The Colour Chaser Touch panel can be connected to a computer via USB.

DMX-installation using Philips ToBeTouched

Philips ToBeTouched is an easy-to-use panel for setting light and colour. The panel’s intuitive design makes the functions simple to understand, enabling the desired light and colour settings to be made.

 

The panel can be mounted over a standard pattress or directly onto a wall. Power supply units could be placed e.g. above a suspended ceiling.

Installation is simple. Use ordinary network cables between the control panel and the loads. Connect each light source or drive unit to a 230 V power supply. Luminaires using DIP-switch addressing can be combined with luminaires using RDM addressing. All devices will be adjusted at the same time.

ToBeTouched 86241 (for full colour control):

  • Touch button for TO/FROM.
  • Two saveable  presets.
  • Manual adjustment of colour (C), intensity (I) and saturation (S).

ToBeTouched 86242 (for colour-temperature control):

  • Touch button for TO/FROM.
  • Two saveable presets.
  • Manual adjustment of colour temperature between 2500 and 6500 K.

DMX installation using DALI Router 920

Control using the Helvar 920 Router. This device has a connection for DMX control of loads, which can be combined with DALI control. This enables advanced RGB control using DMX to be integrated with ordinary fluorescent tube loads and control functions. DMX control is normally limited to a single control unit, but this solution enables all the lighting to be controlled in a more energyefficient and user-friendly manner.

  • Manual adjustment using touch buttons.
  • Sensors for on/off etc.
  • Full calendar control. The light can be programmed in detail according to almanac forecasts and event calendars.
  • Flexible solution for light sources.